lvgl_esp32_drivers/i2c_manager/Kconfig

103 lines
3.2 KiB
Plaintext
Raw Normal View History

menu "I2C Port Settings"
depends on LV_I2C && !HAVE_I2C_MANAGER
menu "I2C Port 0"
config I2C_MANAGER_0_ENABLED
bool "Enable I2C port 0"
if I2C_MANAGER_0_ENABLED
config I2C_MANAGER_0_SDA
int "SDA (GPIO pin)"
config I2C_MANAGER_0_SCL
int "SCL (GPIO pin)"
config I2C_MANAGER_0_FREQ_HZ
int "Frequency (Hz)"
default 400000
range 100000 5000000
help
The clock speed in Hz. Ranges from 100000 (100 kHz) to
5000000 (5 Mhz). I2C busses that involve external wires may
have to be slower, and the real maximum speed the bus will
support depends on the value of the pullup resistors and the
design of the overall circuit.
config I2C_MANAGER_0_TIMEOUT
int "R/W timeout (ms)"
default 20
range 10 1000
help
Timeout for I2C read and write operations. This does not
include the time waiting for a lock.
config I2C_MANAGER_0_LOCK_TIMEOUT
int "Stale lock override (ms)"
default 50
range 10 1000
help
Timeout at which point an operation waiting for its turn on
the port will assume that whatever set the lock has died and
overrides it. Set this somewhat larger than the previous
timeout.
config I2C_MANAGER_0_PULLUPS
bool "Use ESP32 built-in bus pull-up resistors"
help
The I2C bus needs resistors to make sure it's in a defined
state when nobody is talking. Many circuits have external
pullup resistors already and turning these on will increase
power consumption slightly and may limit the speed your bus
can attain. Try with these off first if you don't know.
endif
endmenu
menu "I2C Port 1"
config I2C_MANAGER_1_ENABLED
bool "Enable I2C port 1"
if I2C_MANAGER_1_ENABLED
config I2C_MANAGER_1_SDA
int "SDA (GPIO pin)"
config I2C_MANAGER_1_SCL
int "SCL (GPIO pin)"
config I2C_MANAGER_1_FREQ_HZ
int "Frequency (Hz)"
default 1000000
range 100000 5000000
help
The clock speed in Hz. Ranges from 100000 (100 kHz) to
5000000 (5 Mhz). I2C busses that involve external wires may
have to be slower, and the real maximum speed the bus will
support depends on the value of the pullup resistors and the
design of the overall circuit.
config I2C_MANAGER_1_TIMEOUT
int "R/W timeout (ms)"
default 20
range 10 1000
help
Timeout for I2C read and write operations. This does not
include the time waiting for a lock. Default should be fine.
config I2C_MANAGER_1_LOCK_TIMEOUT
int "Stale lock override (ms)"
default 50
help
Timeout at which point an operation waiting for its turn on
the port will assume that whatever set the lock has died and
overrides it. Set this somewhat larger than the previous
timeout. Default should be fine.
range 30 1000
config I2C_MANAGER_1_PULLUPS
bool "Use ESP32 built-in bus pull-up resistors"
help
The I2C bus needs resistors to make sure it's in a defined
state when nobody is talking. Many circuits have external
pullup resistors already and turning these on will increase
power consumption slightly and may limit the speed your bus
can attain. Try with these off first if you don't know.
endif
endmenu
endmenu